The Working Principle Of The Drying Machine
Through electric power, diesel power, wind, flammable material and other production power using ambient air heating, conveying to the surrounding, and then to reach the appropriate temperature for dehumidification treatment. The concrete process is as follows: The wet material is transported by a belt conveyor or bucket elevator to the hopper, and then the feeding machine of the hopper passes through the feeding pipe into the feeding end. The inclination of the feeding pipe is greater than the natural inclination of the material so that the material can flow smoothly into the dryer. The dryer cylinder is a rotating cylinder that is slightly tilted to the horizontal line. The material is added from the high end, and the load body is entered by the low-end, and the material is in contact with the upstream, and the load body and the material are joined together and flow into the cylinder. As the rotating material of the cylinder is operated by gravity to the bottom end. In the process of moving the wet material in the barrel, the heat of the heat-carrying body is obtained directly or indirectly, so that the wet material can be dried and then sent out by the belt conveyor or screw conveyor at the discharging end. In the cylinder body wall is equipped with a copy board, its function is to copy the material up and down, so that the contact surface of the material and airflow to increase, in order to improve the drying rate and promote the material forward. The heat-carrying body is generally divided into hot air, flue gas and so on. The heat-carrying body after the dryer, generally need cyclone dust catcher in the gas to capture the material. If you need to further reduce the dust content of the tail gas, but also through the bag-type dust catcher or wet dust remover after discharge.